Q. The pressure intensity beneath the footing depends upon ___________

View solution

Q. Once the pressure distribution is known ___________ in the reinforced concrete footing can be calculated.

View solution

Q. In conventional design, allowable bearing capacity should be taken smaller than which of the following value?

View solution

Q. In cohesive soil, the pressure distribution beneath the footing is ___________

View solution

Q. When do strap footings are used in foundation?

View solution

Q. When two column loads are unequal, which of the possible footing can be provided?

View solution

Q. The total settlement of a footing in clay is considered to be consisting of ___________ components.

View solution

Q. The component Sc, used in the total settlement of clay refers to which of the following?

View solution

Q. The immediate settlement can be computed from the expression, based on ____________

View solution

Q. The influence factor for rigid square footing is ____________

View solution

Q. The equation for computing immediate settlement “Si = μ0μ1 q B ( 1-μ2/Es )” was proposed by ___________

View solution

Q. The value of Es used in the immediate settlement equation, can be found out using _____________

View solution

Q. A combined footing may be rectangular in shape if both the columns carry ___________

View solution

Q. The influence factor Iw for rigid rectangular footing with L/B = 1.5 is ____________

View solution

Q. The design of rigid rectangular combined footing consist in determining the ____________

View solution

Q. If the independent spread footing of two columns are connected by a beam, it is called ___________

View solution

Q. Which of the following condition is true regarding the transfer of load from strap to soil, used in strap footing?

View solution

Q. When the allowable soil is low or the building loads are heavy, the footing used is ___________

View solution

Q. If the resultant of the soil pressure coincides with the resultant of the loads, the soil is pressure is assumed to be ____________

View solution

Q. In designing rectangular combined footing _________ should be adopted as the design value.

View solution