Q. Pitch between operating combs of chain is calculated to be

View solution

Q. Feed ratio of rotating flanges is

View solution

Q. Combs per head in chain is calculated to be

View solution

Q. Maximum throughput speed of chain without autoleveller is

View solution

Q. Heads per machine of rotating flanges are

View solution

Q. Number of rotating flanges in feedrack are

View solution

Q. Screws width with needles is

View solution

Q. At ends of comb in chain drafting head, there are

View solution

Q. Combs cannot reach high speed in screw type drawframe due to

View solution

Q. Traditional screw type drawframes provides excellent

View solution

Q. Chains in chain drafting head are

View solution

Q. Formula for speed calculation of comb is

View solution

Q. In combing, all fibers are straightened and parallelized according to sliver's

View solution

Q. Oiling device at entry side features

View solution

Q. Flow of sliver leaving unit is controlled to avoid

View solution

Q. As feeding rate and draft value changes, change also occurs in

View solution

Q. Pitch of return screw as compared to other screws is

View solution

Q. In chain drafting head, combs are driven by

View solution

Q. An intersecting drawframes consists of

View solution

Q. Maximum speed of combs of screw type draw frames is

View solution