Q. Which of the following is the correct ternery diagram for liquid-liquid extraction system comprising of two pairs partly soluble (e.g., chlorobenzene-water-methyl ethyl ketone system) ?

View solution

Q. If moisture content of solid on dry basis is X, then the same on wet basis is

View solution

Q. If xD = overhead product molal composition and RD = reflux ratio, then slope and intercept of the operating line for rectifying section are respectively

View solution

Q. Below is given an equilibrium moisture curve of a substance. State which regions represent free moisture and unbound moisture respectively.

View solution

Q. The following expression is

View solution

Q. Which of the following is the correct ternery diagram for liquid-liquid extraction system comprising of one pair partly soluble (e.g. water-benzene-acetic acid in which A-diluent, B - solvent and C - solute)?

View solution

Q. The velocity, concentration and temperature boundary, for the boundary layer development on a flat plate during connective mass transfer will be same, if

View solution

Q. For the gas absorption, the height of a transfer unit, based on the gas phase is given by (G: superficial molar gas velocity, L: superficial molar liquid velocity, FG:mass transfer co-efficient, mols/m² , a: in-terfacial area per unit volume of tower)

View solution

Q. Relative humidity is the ratio of the

View solution

Q. In batch distillation with constant reflux, overhead product composition __________ with time.

View solution

Q. Psychrometry deals with the properties of gas-vapor mixture. Humidity can be determined by the measurement of the __________ of a fibre.

View solution

Q. Heat in BTU necessary to increase the temperature of 1 lb of gas and its accompanying vapour by 1°F is called the

View solution

Q. To increase the absorption factor, (where, G = gas flow rate, S = solvent flow rate)

View solution

Q. In distillation columns, the number of bubble caps per tray primarily depends upon the

View solution

Q. In distillation, overhead product contains

View solution

Q. With increase in pressure, the relative volatility for a binary system

View solution

Q. Low viscosity absorbent is preferred for reasons of

View solution

Q. Mass transfer co-efficient (K) and diffusivity (D) are related according to film theory as

View solution

Q. Drying operation under vacuum is carried out to

View solution

Q. Air initially at 101. 3 kPa and 40°C and with a relative humidity of 50%, is cooled at constant pressure to 30°C. The cooled air has a

View solution