Q. In multimode injection lasers, the construction of current flow to the strip is obtained in structure by __________

View solution

Q. What is the strip width of injection laser?

View solution

Q. Some refractive index variation is introduced into lateral structure of laser.

View solution

Q. Buried hetero-junction (BH) device is a type of _____________ laser where the active volume is buried in a material of wider band-gap and lower refractive index.

View solution

Q. In Buried hetero-junction (BH) lasers, the optical field is confined within __________

View solution

Q. A double-channel planar buried hetero-structure (DCP BH) has a planar active region, the confinement material is?

View solution

Q. Problems resulting from parasitic capacitances can be overcome __________

View solution

Q. Quantum well lasers are also known as __________

View solution

Q. Quantum well lasers are providing high inherent advantage over __________

View solution

Q. Strip geometry of a device or laser is important.

View solution

Q. Better confinement of optical mode is obtained in __________

View solution

Q. Multi-quantum devices have superior characteristics over __________

View solution

Q. Dot-in-well device is also known as __________

View solution

Q. A BH can have anything from a single electron to several electrons.

View solution

Q. QD lasers have a very low threshold current densities of range __________

View solution

Q. __________________ may be improved through the use of frequency-selective feedback so that the cavity loss is different for various longitudinal modes.

View solution

Q. Device which apply the frequency-selective feedback technique to provide single longitudinal operation are referred to as ________________

View solution

Q. Which of the following does not provide single frequency operation?

View solution

Q. A method for increasing the longitudinal mode discrimination of an injection laser which is commonly used?

View solution

Q. Conventional cleaved mirror structures are difficult to fabricate with the cavity lengths below __________

View solution