Q. Device which apply the frequency-selective feedback technique to provide single longitudinal operation are referred to as ________________

View solution

Q. Which of the following does not provide single frequency operation?

View solution

Q. A method for increasing the longitudinal mode discrimination of an injection laser which is commonly used?

View solution

Q. Conventional cleaved mirror structures are difficult to fabricate with the cavity lengths below __________

View solution

Q. In the given equation, corrugation period is given by lλᵦ/2Nₑ. If λᵦ is the Bragg wavelength, then what does ‘l’ stand for?

View solution

Q. The first order grating (l=1) provide the strongest coupling within the device.

View solution

Q. The semiconductor lasers employing the distributed feedback mechanism are classified in _________________ categories.

View solution

Q. DBF-BH lasers exhibit low threshold currents in the range of ________________

View solution

Q. Fabry-Perot devices with BH geometries high modulation speeds than DFB-BH lasers.

View solution

Q. The InGaAsP/InP double channel planar DFB-BH laser with a quarter wavelength shifted first order grating provides a single frequency operation and incorporates a phase shift of ______________

View solution

Q. The narrow line-width obtained under the CW operation for quarter wavelength shifted DFB laser is ________________

View solution

Q. Line-width narrowing is achieved in DFB lasers by a strategy referred as _______________

View solution

Q. _________________ is a technique used to render the non-conducting material around the active cavity by producing permanent defects in the implanted area.

View solution

Q. The threshold temperature coefficient for InGaAsP devices is in the range of __________

View solution

Q. The process where the energy released during the recombination of an electron-hole event getting transferred to another carrier is known as __________

View solution

Q. Auger recombination can be reduced by using __________

View solution

Q. High strain in strained structure should be incorporated.

View solution

Q. The parameter that prevents carrier from recombination is __________

View solution

Q. Determine the threshold current density for an AlGaAs injection laser with T₀=180k at 30°C.

View solution

Q. The phenomenon occurring when the electron and photon population within the structure comes into equilibrium is known as __________

View solution