Q. The Euler's equation for the motion of liquids is based upon the assumption that

View solution

Q. A weir is usually made of masonry or concrete.

View solution

Q. The discharge over a rectangular weir, considering the velocity of approach, is (where H1 = Total height of water above the weir = H + Ha H = Height of water, over the crest of the weir, and Ha = Height of water, due to velocity of approach)

View solution

Q. A flow in which __________ force is dominating over the viscosity is called turbulent flow.

View solution

Q. If an incompressible liquid is continuously flowing through a pipe, the quantity of liquid passing per second is different at different sections.

View solution

Q. The atmospheric pressure at sea level is

View solution

Q. When the pressure intensity at a point is less than the local atmospheric pressure, then the difference of these two pressures is called vacuum pressure.

View solution

Q. Reynold's number is the ratio of inertia force to

View solution

Q. The unit of dynamic viscosity in S.I. units is

View solution

Q. Bulk modulus of a fluid __________ as the pressure increases.

View solution

Q. The hydraulic gradient line may be above or below the centre line of the pipe.

View solution

Q. A water tank contains 1.3 m deep water. The pressure exerted by the water per metre length of the tank is

View solution

Q. The specific gravity has no units.

View solution

Q. The depth of water in a channel corresponding to the minimum specific energy is known as critical depth.

View solution

Q. The ratio of the inertia force to the gravity force is called Froude number.

View solution

Q. Which of the following statement is wrong?

View solution

Q. A glass tube of smaller diameter is used while performing an experiment for the capillary rise of water because

View solution

Q. The viscosity of a liquid is due to cohesion of its particles.

View solution

Q. A compound pipe is required to be replaced by a new pipe. The two pipes are said to be equivalent, if

View solution

Q. In a footstep bearing, if the speed of the shaft is doubled, then the torque required to overcome the viscous resistance will be

View solution