Q. Kinematic viscosity is the product of dynamic viscosity and the density of the liquid.

View solution

Q. A pipe of length more than double the diameter of orifice fitted externally or internally to the orifice is called a

View solution

Q. A vertical wall is subjected to a pressure due to one kind of liquid, on one of its sides. The total pressure on the wall acts at a distance __________ from the liquid surface.

View solution

Q. A nozzle is generally made of

View solution

Q. The unit of surface tension is

View solution

Q. The force of buoyancy is always __________ the weight of the liquid displaced by the body.

View solution

Q. The coefficient of discharge is the ratio of dieoretical discharge to the actual discharge through an orifice.

View solution

Q. The quantity of a liquid flowing per second through a section of a pipe or a channel is called discharge and is measured in cumecs (m³/s).

View solution

Q. The purpose of a surge tank is

View solution

Q. A fluid which obeys the Newton's law of viscosity is termed as

View solution

Q. A notch is, usually, made of a metallic plate.

View solution

Q. In an internal mouthpiece, if the jet after contraction expands and fills up the whole mouthpiece, then the mouthpiece is said to be running free.

View solution

Q. A channel is said to be of most economical cross-section, if

View solution

Q. The top of the weir over which the water flows is known as

View solution

Q. A moving fluid mass may be brought to a static equilibrium position, by aplying an imaginary inertia force of the same magnitude as that of the accelerating force but in the opposite direction. This statement is called

View solution

Q. The pressure at a stagnation point is always low.

View solution

Q. When an internal mouthpiece is running full, the discharge through the mouthpiece is twice the discharge when it is running free.

View solution

Q. In two dimensional flow, the flow does not take place in a curve.

View solution

Q. In order to avoid tendency of separation at throat in a venturimeter, the ratio of the diameter at throat to the diameter of pipe should be

View solution

Q. The ratio of the inertia force to the __________ is called Euler's number.

View solution