Q. A closed cycle gas turbine gives __________ efficiency as compared to an open cycle gas turbine.

View solution

Q. Gas turbine as compared to steam turbine

View solution

Q. Intercooling in gas turbines

View solution

Q. When the temperature of air leaving the intercooler, in a two stage compression with intercooler, is __________ the original atmospheric air temperature, then the intercooling is known as perfect or complete intercooling.

View solution

Q. Free air is the air at atmospheric conditions at any specific location.

View solution

Q. A gas turbine used in air-craft should have low weight and small frontal area.

View solution

Q. A closed cycle gas turbine works on

View solution

Q. The clearance, in a single stage, single acting reciprocating air compressor does not effect the workdone on the air and the power required for compressing the air.

View solution

Q. Air motors work on the cycle which is the reverse of the reciprocating air compressor cycle.

View solution

Q. Which of the following statement is correct relating to rocket engines ?

View solution

Q. In reciprocating air compressors, isothermal efficiency is used for all sorts of calculations.

View solution

Q. Euler's equation can be used for

View solution

Q. A rocket engine uses __________ for the combustion of its fuel.

View solution

Q. The perfect intercooling, in multistage compression, means that the temperature of air at inlet to subsequent stages is equal to the initial temperature.

View solution

Q. A closed cycle gas turbine consists of a

View solution

Q. For maximum work, the reheating should be done to an intermediate pressure of (where p1 = Maximum pressure, and p2 = Minimum pressure)

View solution

Q. The intercooler pressure, for minimum work required, for a two stage reciprocating air compressor, is given by (where p1 = Intake pressure of air, p2 = Intercooler pressure, and p3 = Delivery pressure of air)

View solution

Q. The pressure of air at the beginning of the compression stroke is __________ the atmospheric pressure.

View solution

Q. The pressure ratio in a centrifugal compressor can be increased by increasing the tip speed and lowering the inlet temperature.

View solution

Q. If p1 is the pressure of air entering the L.P, cylinder and p3 is the pressure of air leaving the H.P. cylinder, then the ratio of cylinder diameters for a single acting, two stage reciprocating compressor with complete intercooling is given by

View solution