Q. Upto the critical radius of insulation,

View solution

Q. The relative humidity lines on a psychrometric chart are

View solution

Q. The C.O.P. of a heat pump working on a reversed Carnot cycle is

View solution

Q. A vapour absorption refrigeration system

View solution

Q. The comfort conditions in air conditioning are at (where DBT = Dry bulb temperature, and RH = Relative humidity)

View solution

Q. The dry bulb temperature lines, on the psychrometric chart are

View solution

Q. The pressure at the outlet of a refrigerant compressor is called

View solution

Q. A simple air cooling system is good for __________ flight speeds.

View solution

Q. The highest temperature during the cycle in a vapour compression system occurs after evaporation.

View solution

Q. The rato of energy transferred by convection to that by conduction is called

View solution

Q. A refrigerating system operating on reversed Brayton refrigeration cycle is used for maintaining 250 K. If the temperature at the end of constant pressure cooling is 300 K and rise in the temperature of air in the refrigerator is 50 K, then the net work of compression will be (assume air as working substance with cp = 1 kJ/kg)

View solution

Q. Wet bulb temperature indicates the moisture content in air.

View solution

Q. A designer chooses the values of fluid flow rates and specific heats in such a manner that the heat capacities of the two fluids are equal. A hot fluid enters the counter flow heat exchanger at 100° C and leaves at 60° C. A cold fluid enters the heat exchanger at 40° C. The mean temperature difference between the two fluids is

View solution

Q. The inclined and non-uniformly spaced straight lines on a psychrometric chart indicates wet bulb temperature.

View solution

Q. In a psychrometric chart, dew point temperature lines are horizontal and non-uniformly spaced.

View solution

Q. If the evaporator temperature is kept constant, the coefficient of performance of a refrigeration cycle __________ with the increase in condenser temperature.

View solution

Q. The by-pass factor, in case of sensible cooling of air, is given by (where td1 = Dry bulb temperature of air entering the cooling coil, td2 = Dry bulb temperature of air leaving the cooling coil, and td3 = Dry bulb temperature of the cooling coil)

View solution

Q. The evaporator used in house-hold refrigerators is

View solution

Q. The drier in a refrigeration system removes moisture in the system.

View solution

Q. When the discharge pressure is too high in a refrigeration system, high pressure control is installed to stop the compressor.

View solution