Question
a.
move actually
b.
do not move actually
c.
affect the intervening medium
d.
does not affect the intervening medium
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The process of heat transfer from one particle of the body to another is called conduction, when the particles of the body
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The human body feels comfortable when the heat stored in the body is
View solution
Q. A Bell Coleman refrigerator working on dense air system as compared to open air system, for the same range of temperature, results in __________ power per tonne of refrigeration.
View solution
Q. The amount of heat flow through a body by conduction is
View solution
Q. The emissive power of a body depends upon its
View solution
Q. An electric cable of aluminium conductor (k = 240 W/mK) is to be insulated with rubber (k = 0.15 W/mK). The cable is to be located in air (h = 6 W/m²). The critical thickness of insulation will be
View solution
Q. A cube at high temperature is immersed in a constant temperature bath. It loses heat from its top, bottom and side surfaces with heat transfer coefficients of h1, h2 and h3 respectively. The average heat transfer coefficient for the cube is
View solution
Q. The dehumidification process, on the psychrometric chart, is shown by
View solution
Q. The vertical and uniformly spaced lines on a psychrometric chart indicates
View solution
Q. A furnace is made of a red brick wall of thickness 0.5 m and conductivity 0.7 W/mK. For the same heat loss and temperature drop, this can be replaced by a layer of diatomite earth of conductivity 0.14 W/mK and thickness
View solution
Q. In a refrigeration system, the expansion device is connected between the
View solution
Q. The heat rejection factor (HRF) is given by
View solution
Q. Wein's law states that the wave length corresponding to __________ is proportional to the absolute temperature.
View solution
Q. In a domestic vapour compression refrigerator, the refrigerant commonly used is
View solution
Q. In case of sensible heating of air, the coil efficiency is given by (where B.P.F. = By-pass factor)
View solution
Q. The coefficient of performance (C.O.P.) is the reciprocal of the efficiency of a heat engine.
View solution
Q. The wet bulb temperature at 100% relative humidity is __________ dry bulb temperature.
View solution
Q. The freezing point of sulphur dioxide is
View solution
Q. The ratio of the energy absorbed by the body to the total energy falling on it, is called
View solution
Q. In order to cool and dehumidify a stream of moist air, it must be passed over the coil at a temperature
View solution
Q. The coefficient of performance of vapour compression refrigeration system is quite __________ as compared to air refrigeration system.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!