Q. In American Standard Association (A S A) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be

View solution

Q. The lip clearance angle should decrease towards the centre of the drill than at the circumference.

View solution

Q. If the shear angle is large and the chip-tool contact area is low, then the tool life will be more.

View solution

Q. In drilling brass, a drill with

View solution

Q. The carbide tools operating at very low cutting speeds (below 30 m/min)

View solution

Q. In oblique cutting of metals, the cutting edge of the tool is

View solution

Q. The grinding of long, slender shafts or bars is usually done by

View solution

Q. In centreless grinding, work place centre will be

View solution

Q. Tool life is measured by the

View solution

Q. Soft materials can not be economically ground due to

View solution

Q. The process of removing metal by a cutter which is rotated in the same direction of travel of workpiece, is called

View solution

Q. Crater wear is mainly due to the phenomenon known as

View solution

Q. The cutting speed for drilling aluminium, brass and bronze with high speed steel drills varies from

View solution

Q. Flank wear depends upon the

View solution

Q. The tool may fail due to

View solution

Q. The operation of machining several surfaces of a workpiece simultaneously is called

View solution

Q. The abrasive recommended for grinding materials of low tensile strength is

View solution

Q. The chamfering is an operation of

View solution

Q. The hard grade grinding wheels are denoted by the letters

View solution

Q. The tailstock set over required to turn a taper on the entire length of a workpiece having diameters D and d is

View solution