Q. The cutting speed for drilling aluminium, brass and bronze with carbon steel drills is __________ cutting speed for drilling mild steel with high speed steel drills.

View solution

Q. In electro-discharge machining, the tool is connected to cathode.

View solution

Q. The effect of setting a boring tool above centre height leads to

View solution

Q. Which of the following statement is correct about nose radius?

View solution

Q. The cutting speed for drilling __________ with high speed steel drills is 24 to 45 m/min.

View solution

Q. In a centre lathe, the cutting tool is fed in __________ with reference to the lathe axis.

View solution

Q. The angle between the face of the tool and a line tangent to the machined surface at the cutting point is called cutting angle.

View solution

Q. If the grain size is __________ the tool life is better.

View solution

Q. Flank wear is due to the abrasive action of hard mis-constituents including debris from built up edge as the work material rubs the work surface.

View solution

Q. The operation of reproduction of an outline of a template on a workpiece is called face milling.

View solution

Q. The usual value of the point angle of a drill is

View solution

Q. Buffing wheels are made of

View solution

Q. In drilling mild steel and brass, the point angle of a drill is 118°.

View solution

Q. The tail stock set over method of taper turning is preferred for

View solution

Q. The chuck preferred for quick setting and accurate centering of a job is

View solution

Q. Negative rakes are used for

View solution

Q. A bottoming tap has

View solution

Q. The enlarging of an existing circular hole with a rotating single point tool is called

View solution

Q. In the relation VTn = C, the value of n for high speed steel tools varies from 0.25 to 0.40.

View solution

Q. Glazing in grinding wheels __________ cutting capacity.

View solution