Question
a.
It can not be used on old machines due to backlash between the feed screw of the table and the nut.
b.
The chips are disposed off easily and do not interfere with the cutting.
c.
The surface milled appears to be slightly wavy.
d.
The coolant can be poured directly at the cutting zone where the cutting force is maximum.
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which of the following statement is correct as regard to up milling?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In order to obtain a surface finish in the range of 0.75 μm to 1.25 μm , the operation used is called.
View solution
Q. The angle between the face and flank of the single point cutting tool is known as
View solution
Q. The parameter which completely defines the chip formation in a metal cutting process is
View solution
Q. A lathe with four steps on the cone pulley and with backgears will have
View solution
Q. The increase in depth of cut and feed rate __________ surface finish.
View solution
Q. Holes are machined by push broaches only for sizing.
View solution
Q. In gear hobbing
View solution
Q. EDM machining is applied for
View solution
Q. A fine grained grinding wheel is used to grind
View solution
Q. When the shear angle is small
View solution
Q. In oblique cutting system, the cutting edge of the tool
View solution
Q. Hard and tough materials like cast iron should be turned at
View solution
Q. The cutting speed for counter-boring should be __________ that of drilling operation.
View solution
Q. The usual value of the helix angle of a drill is
View solution
Q. Glazing in grinding wheels __________ cutting capacity.
View solution
Q. In the relation VTn = C, the value of n for high speed steel tools varies from 0.25 to 0.40.
View solution
Q. The enlarging of an existing circular hole with a rotating single point tool is called
View solution
Q. A bottoming tap has
View solution
Q. Negative rakes are used for
View solution
Q. The chuck preferred for quick setting and accurate centering of a job is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
