Q. Two shafts 'A' and 'B' transmit the same power. The speed of shaft 'A' is 250 r.p.m. and that of shaft 'B' is 300 r.p.m. The shaft 'B' has the greater diameter.

View solution

Q. The stress induced in a body, when suddenly loaded, is __________ the stress induced when the same load is applied gradually.

View solution

Q. The point of contraflexure is a point where

View solution

Q. The simply supported beam 'A' of length l carries a central point load W. Another beam 'B' is loaded with a uniformly distributed load such that the total load on the beam is W. The ratio of maximum deflections between beams A and B is

View solution

Q. The maximum stress produced in a bar of tapering section is at

View solution

Q. The energy stored in a body when strained within elastic limit is known as

View solution

Q. In compression test, the fracture in cast iron specimen would occur along

View solution

Q. In the torsion equation the term J/R is called

View solution

Q. Strain resetters are used to

View solution

Q. The torque transmitted by a solid shaft of diameter (D) is (where τ = Maximum allowable shear stress)

View solution

Q. When a rectangular beam is loaded transversely, the maximum compressive stress is developed on the

View solution

Q. The bending stress in a beam is __________ section modulus.

View solution

Q. When shear force at a point is zero, then bending moment is __________ at that point.

View solution

Q. When a bar is cooled to - 5°C, it will develop

View solution

Q. The limit of eccentricity is based upon no tension condition.

View solution

Q. The strain energy stored in a solid circular shaft subjected to shear stress (τ) is (where C = Modulus of rigidity for the shaft material)

View solution

Q. When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as __________ double cover butt joint.

View solution

Q. Whenever a material is loaded within elastic limit, stress is __________ strain.

View solution

Q. A load which is spread over a beam in such a manner that it varies uniformly over the whole length of abeam is called uniformly __________ load.

View solution

Q. Which of the following statement is correct?

View solution