Q. Geometric similarity is said to exist between the model and the prototype, if both of them

View solution

Q. A Francis turbine is used when the available head of water is

View solution

Q. The specific speed from 160 to 500 r.p.m. of a centrifugal pump indicates that the pump is

View solution

Q. A hydraulic coupling belongs to the category of

View solution

Q. The principle of jet propulsion is used in driving the ships and aeroplanes.

View solution

Q. In the casing of a centrifugal pump, the kinetic energy of the water is converted into pressure energy before the water leaves the casing.

View solution

Q. Which of the following pump is preferred for flood control and irrigation applications?

View solution

Q. The efficiency of a Pelton wheel working under constant head __________ with the increase in power.

View solution

Q. The discharge of a centrifugal pump working under constant head __________ with the speed.

View solution

Q. The unit discharge through the turbine is

View solution

Q. Delivery head of water of a centrifugal pump is inversely proportional to diameter of its impeller.

View solution

Q. Power required to drive a centrifugal pump is directly proportional to __________ of its impeller.

View solution

Q. The mechanical efficiency of an impulse turbine is

View solution

Q. The overshot water wheels are those in which the wheel runs entirely by the __________ of water.

View solution

Q. In a Kaplan turbine runner, the number of blades are generally between

View solution

Q. If Hg is the gross or total head and hf is the head lost due to friction, then net or effective head (H) is given by

View solution

Q. The speed of an imaginary turbine, identical with the given turbine, which will develop a unit power under a unit head, is known as

View solution

Q. For centrifugal pump impeller, the maximum value of the vane exit angle is

View solution

Q. In a reaction turbine, the pressure head of water, while flowing over the vanes, is converted into kinetic head before leaving the wheel.

View solution

Q. Manometric head, in case of a centrifugal pump, is equal to

View solution