Question
a.
in decreasing the slip of the belt
b.
in increasing the slip of the belt
c.
to keep the belt in centre on a pulley while it is in motion
d.
to increase pulley life
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Crowning on pulley helps
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The temperature required for full annealing in hyper-eutectoid steel is
View solution
Q. The effect of key ways on a shaft is to reduce its load carrying capacity and to increase its torsional rigidity.
View solution
Q. The efficiency of a riveted joint is equal to
View solution
Q. Which of the following formula is used in designing a connecting rod ?
View solution
Q. When a material is subjected to fatigue loading, the ratio of the endurance limit to the ultimate tensile strength is
View solution
Q. The lead angle of a worm is 22.5°. Its helix angle will be
View solution
Q. The root angle of a bevel gear is equal to
View solution
Q. Antifriction bearings are
View solution
Q. Stress concentration factor is defined as the ratio of
View solution
Q. The property of a bearing material which has the ability to accomodate shaft deflections and bearing inaccuracies by plastic deformation without excessive wear and heating, is known as
View solution
Q. In the levers of __________ type, the mechanical advantage is less than one.
View solution
Q. A hollow saddle key is
View solution
Q. Pitch point of a cam is
View solution
Q. When two parallel and coplaner shafts are connected by gears having teeth parallel to the axis of the shaft, the arrangement is known as spiral gearing.
View solution
Q. A screw is specified by its
View solution
Q. The wear load should be __________ the dynamic load.
View solution
Q. The velocity factor for ordinary cut gears operating at velocities upto 12.5 m/s is equal to
View solution
Q. The property of a bearing material which has the ability to accomodate small particles of dust, grit etc. without scoring the material of the journal, is called
View solution
Q. The shock resistance of steel is increased by adding
View solution
Q. The ratio of driving tensions for flat belts, neglecting centrifugal tension, is (where T1, and T2 = Tensions on the tight and slack sides of belt respectively, μ = Coefficient of friction, between the belt and pulley, and θ = Angle of contact)
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
