Question
a.
0.20
b.
0.35
c.
0.50
d.
0.65
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. When a material is subjected to fatigue loading, the ratio of the endurance limit to the ultimate tensile strength is
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The lead angle of a worm is 22.5°. Its helix angle will be
View solution
Q. The root angle of a bevel gear is equal to
View solution
Q. Antifriction bearings are
View solution
Q. Stress concentration factor is defined as the ratio of
View solution
Q. The property of a bearing material which has the ability to accomodate shaft deflections and bearing inaccuracies by plastic deformation without excessive wear and heating, is known as
View solution
Q. In the levers of __________ type, the mechanical advantage is less than one.
View solution
Q. A hollow saddle key is
View solution
Q. Pitch point of a cam is
View solution
Q. When two parallel and coplaner shafts are connected by gears having teeth parallel to the axis of the shaft, the arrangement is known as spiral gearing.
View solution
Q. A screw is specified by its
View solution
Q. The wear load should be __________ the dynamic load.
View solution
Q. The velocity factor for ordinary cut gears operating at velocities upto 12.5 m/s is equal to
View solution
Q. The property of a bearing material which has the ability to accomodate small particles of dust, grit etc. without scoring the material of the journal, is called
View solution
Q. The shock resistance of steel is increased by adding
View solution
Q. The ratio of driving tensions for flat belts, neglecting centrifugal tension, is (where T1, and T2 = Tensions on the tight and slack sides of belt respectively, μ = Coefficient of friction, between the belt and pulley, and θ = Angle of contact)
View solution
Q. A flange coupling is a type of rigid coupling.
View solution
Q. The strength of the un-riveted plate (P) per pitch length is equal to
View solution
Q. Two shafts of the same length and material are joined in series. If the ratio of their diameters is 2, then the ratio of their angles of twist will be
View solution
Q. Wahl's stress factor __________ very rapidly as the spring index decreases.
View solution
Q. For circumferential joint in boilers, the type of joint used is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
