Q. Two rigid plates are clamped by means of bolt and nut with an initial force F. After tightening, a separating force P (P < F) is applied to the lower plate, which in turn acts on the nut. The tension in the both after this is

View solution

Q. The bearings of medium series have capacity __________ over the light series.

View solution

Q. The antifriction bearings

View solution

Q. In a partial journal bearing, the angle of contact of the bearing with the journal is

View solution

Q. A shaft coupling should

View solution

Q. A screw is said to be over hauling screw, if the

View solution

Q. Shaft coupling is used in machinery to

View solution

Q. Oldham coupling is used to connect two shafts

View solution

Q. The ends of the leaves of a semi-elliptical leaf spring are made triangular in order to

View solution

Q. The face of the tooth is the

View solution

Q. In case of pressure vessels having open ends, the fluid pressure induces

View solution

Q. The set screws are used to prevent relative motion between the two parts.

View solution

Q. The face angle of a bevel gear is equal to

View solution

Q. Two shafts will have equal strength, if

View solution

Q. The size of a cam depends upon

View solution

Q. A turn buckle is used to connect two round rods subjected to tensile loading and requiring subsequent adjustment for tightening or loosening.

View solution

Q. The plasticity is the property of a material which enables it to

View solution

Q. An open coiled helical compression spring 'A' of mean diameter 50 mm is subjected to an axial load W. Another spring 'B' of mean diameter 25 mm is similar to spring 'A' in all respects. The deflection of spring 'B' will be __________ as compared to spring 'A'.

View solution

Q. When the bolt is very yielding as compared to the connected members, then the resultant load on the bolt will be equal to the

View solution

Q. During hot working of metals,

View solution