Question
a.
The solid length of a spring is the product of total number of coils and the diameter of the wire
b.
The spring index is the ratio of mean diameter of the coil to the diameter of the wire
c.
The spring stiffness is the load required per unit deflection of the spring
d.
The pitch of the coil is the axial distance between adjacent coils in the compressed state
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Which of the following statement is wrong ?
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The draw of cotter should not be more than
View solution
Q. The bolts of smaller diameter than M16 are not permitted in making fluid tight joints.
View solution
Q. In a marine flange coupling, the pitch circle diameter of bolts is taken as
View solution
Q. The steel widely used for motor car crankshafts is
View solution
Q. When compared to the rod of the same diameter and material, a wire rope
View solution
Q. According to Indian standards, total number of fundamental deviations are
View solution
Q. In the calculation of induced shear stress in helical springs, the Wahl's stress factor is used to take care of
View solution
Q. Creep in belt is due to
View solution
Q. The minimum number of teeth on the pinion which will mesh with any gear without interference for 20° full depth involute teeth will be
View solution
Q. A bolt of M 24 x 2 means that
View solution
Q. In designing a sleeve coupling, outer diameter of the sleeve is taken as (where d = Diameter of the shaft)
View solution
Q. In order to ensure self locking in a screw jack, it is essential that helix angle is __________ friction angle.
View solution
Q. In case of thick cylinders, the tangential stress across the thickness of cylinder is
View solution
Q. The cam follower generally used in automobile engines is
View solution
Q. A closely coiled helical spring is acted upon by an axial force. The maximum shear stress developed in the spring is τ . The half of the length of the spring if cut off and the remaining spring is acted upon by the same axial force. The maximum shear stress in the spring in new condition will be
View solution
Q. The malleable material should be plastic but is not essential to be so strong.
View solution
Q. The temperature at which the new grains are formed in the metal is known as
View solution
Q. Deep groove ball bearings are used for
View solution
Q. The shear modulus of resilience is proportional to
View solution
Q. In a sawn nut, a slot is cut about half way through the nut and a small screw is tightened between the nut and the bolt in order to produce more friction.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
