Question
a.
repeated stress
b.
yield stress
c.
fluctuating stress
d.
alternating stress
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The stress which vary from a minimum value to a maximum value of the same nature (i.e. tensile or compressive) is called
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be
View solution
Q. The pressure angle for involute gears depends upon the size of teeth.
View solution
Q. When a belt drive is transmitting maximum power,
View solution
Q. Gears are casted by
View solution
Q. A screw is said to be a self locking screw, if its efficiency is
View solution
Q. An aluminium member is designed on the basis of
View solution
Q. A plate with a circular hole in the centre is subjected to a pull of P. The maximum stress induced at the edge of the hole is three times of the nominal stress.
View solution
Q. The cold working of metals is carried out __________ the recrystallisation temperature.
View solution
Q. The groove angle of the pulley for rope drive is usually
View solution
Q. When percentage of carbon in steel is increased, the ductility of steel decreases.
View solution
Q. The shock absorbing capacity of a bolt may be increased by
View solution
Q. A lap joint is always in single shear.
View solution
Q. If b denotes the face width and L denotes the cone distance for a bevel gear, then the bevel factor is written as
View solution
Q. The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using
View solution
Q. The ratio of pitch circle diameter in millimetres to the number of teeth, is called
View solution
Q. According to Indian standard specifications, 100 H6/g5 means that
View solution
Q. Rankine Gordon formula for buckling is valid for
View solution
Q. The angle of twist of shaft is
View solution
Q. A long helical spring having a spring stiffness of 12 kN/m and number of turns 20, breaks into two parts with number of turns 10 each in both the parts. If the two parts are connected in series, then the softness of the resultant spring will be
View solution
Q. The radial distance from the __________ to the clearance circle is called working depth.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
