Q. When a belt drive is transmitting maximum power,

View solution

Q. Gears are casted by

View solution

Q. A screw is said to be a self locking screw, if its efficiency is

View solution

Q. An aluminium member is designed on the basis of

View solution

Q. A plate with a circular hole in the centre is subjected to a pull of P. The maximum stress induced at the edge of the hole is three times of the nominal stress.

View solution

Q. The cold working of metals is carried out __________ the recrystallisation temperature.

View solution

Q. The groove angle of the pulley for rope drive is usually

View solution

Q. When percentage of carbon in steel is increased, the ductility of steel decreases.

View solution

Q. The shock absorbing capacity of a bolt may be increased by

View solution

Q. A lap joint is always in single shear.

View solution

Q. If b denotes the face width and L denotes the cone distance for a bevel gear, then the bevel factor is written as

View solution

Q. The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using

View solution

Q. The ratio of pitch circle diameter in millimetres to the number of teeth, is called

View solution

Q. According to Indian standard specifications, 100 H6/g5 means that

View solution

Q. Rankine Gordon formula for buckling is valid for

View solution

Q. The angle of twist of shaft is

View solution

Q. A long helical spring having a spring stiffness of 12 kN/m and number of turns 20, breaks into two parts with number of turns 10 each in both the parts. If the two parts are connected in series, then the softness of the resultant spring will be

View solution

Q. The radial distance from the __________ to the clearance circle is called working depth.

View solution

Q. The efficiency of a square threaded screw is maximum if the helix angle is equal to (where φ = Angle of friction)

View solution

Q. In designing thick cylinders, the equation used is

View solution