Question
a.
slotted for a screw driver and are generally used with a nut
b.
similar to tap bolts except that they are of small size and a variety of shapes of heads are available
c.
used to prevent relative motion between the two parts
d.
none of the above
Posted under Mechanical Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The cap screws are
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In skew bevel gearing, the axes of shafts are
View solution
Q. A chain drive transmits __________ power as compared to belt drive.
View solution
Q. The stress in the bar when the load is applied suddenly is __________ as compared to the stress induced due to gradually applied loads.
View solution
Q. A triple riveted butt joint with double straps of unequal width is to be designed for a boiler shell. The pitch of the rivets in the outer row is double the pitch in the inner row and zig-zag riveting is proposed. Which of the following statement is correct?
View solution
Q. The form factor of a helical gear __________ with the increase in the helix angle.
View solution
Q. The taper on a rectangular sunk key is
View solution
Q. When carbon in the cast iron is in the form of cementite, the cast iron will be of white colour.
View solution
Q. A type of brake commonly used in motor cars is a
View solution
Q. In a nut and bolt, the diameter at which the ridges on the bolt are in complete touch with the ridges of the corresponding nut, is called pitch diameter.
View solution
Q. A double strap butt joint (with equal straps) is
View solution
Q. For a bevel gear having the pitch angle θ , the ratio of formative number of teeth (TE) to actual number of teeth (T) is
View solution
Q. The modulus of elasticity for mild steel is approximately equal to
View solution
Q. A connecting rod subjected to an axial load may buckle with
View solution
Q. When the lubricant is forced between the journal and the bearing by external pressure, the bearing is called hydrostatic lubricated bearing.
View solution
Q. Crushing resistance required to crush the rivet per pitch length is
View solution
Q. Tearing resistance required to tear off the plate per pitch length is (where p = Pitch of rivets, d = Dia. of rivet hole, and σt = Permissible tensile stress for plate material)
View solution
Q. The buttress threads have low frictional resistance characteristic of the square threads and have the same strength of V-threads.
View solution
Q. The tension on the slack side of the belt is __________ the tension on the tight side of the belt.
View solution
Q. The property of a material which enables it to resist fracture due to high impact loads, is called toughness.
View solution
Q. The resultant axial load on a bolt depends upon
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Mechanical Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!