Q. The maximum and minimum value of the tractive force is given by

View solution

Q. In a turning moment diagram, the variations of energy above and below the mean resisting torque line is called

View solution

Q. In a spring controlled governor, when the controlling force __________ as the radius of rotation increases, it is said to be a stable governor.

View solution

Q. The distance between the centre of suspension and centre of percussion is equal to the equivalent length of a simple pendulum.

View solution

Q. When the body is suspended at the point of suspension, its periodic time and frequency will be __________ as compared to the body suspended at the point of percussion.

View solution

Q. A reed type tachometer use the principle of

View solution

Q. The natural frequency of free transverse vibrations due to a point load acting over a simply supported shaft is equal to (where δ = Static deflection of a simply supported shaft due to the point load)

View solution

Q. When the sleeve of a Porter governor moves upwards, the governor speed

View solution

Q. The retardation of a flat faced follower when it has contact at the apex of the nose of a circular arc cam, is given by (where OQ = Distance between the centre of circular flank and centre of nose)

View solution

Q. A thin circular disc is rolling with a uniform linear speed, along a straight path on a plane surface. Which of the following statement is correct in this regard ?

View solution

Q. A body will begin to move down an inclined plane, if the angle of inclination of the plane is __________ the angle of friction.

View solution

Q. The fundamental equation for correct steering is (where φ and α = Angle through which the axis of the outer wheel and inner wheel turns respectively, c = Distance between the pivots of the front axles, and d = Wheel base)

View solution

Q. The height of a Watt's governor is

View solution

Q. For an isochronous Hartnell governor (where r1 and r2 = Maximum and minimum radius of rotation of balls respectively, S1 and S2 = Maximum and minimum force exerted on the sleeve respectively, and M = Mass on the sleeve)

View solution

Q. Which of the following statement is correct ?

View solution

Q. When the speed of the engine fluctuates continuously above and below the mean speed, the governor is said to be

View solution

Q. When two pulleys of different diameters are connected by means of an open belt, the angle of contact at the __________ pulley must be taken into consideration.

View solution

Q. The maximum frictional force, which comes into play, when an body just begins to slide over the surface of the other body, is known as

View solution

Q. In a four stroke I.C. engine, the turning moment during the compression stroke is

View solution

Q. The module is the reciprocal of diametral pitch.

View solution