Q. Plotting of inaccessible points on a plane table, is done by

View solution

Q. A dumpy level is set up with its eye-piece vertically over a peg A. The height from the top of peg A to the centre of the eye-piece is 1.540 m and the reading on peg B is 0.705 m. The level is then setup over B. The height of the eye-piece above peg B is 1.490 m and a reading on A is 2.195 m. The difference in level between A and B is

View solution

Q. Probable systematic error in precise levelling as recommended by International Geodetic Association should not exceed (where k is in kilometers.)

View solution

Q. The diaphragm of a stadia theodolite is fitted with two additional

View solution

Q. Centering error of a theodolite produces an error

View solution

Q. In levelling operation

View solution

Q. Pick up the correct statement from the following :

View solution

Q. In optical reading instruments

View solution

Q. For setting out a simple curve, using two theodolites.

View solution

Q. Geodetic surveying is undertaken

View solution

Q. The desired sensitivity of a bubble tube with 2 mm divisions is 30". The radius of the bubble tube should be

View solution

Q. A dumpy level was set up at the midpoint between two pegs A and B, 50 m apart and the staff readings at A and B were 1.22 and 1.06. With the level set up a A, the readings at A and B were 1.55 and 1.37. The collimation error per 100 m length of sight is

View solution

Q. If the rate of gain of radial acceleration is 0.3 m per sec³ and full centrifugal ratio is developed. On the curve the ratio of the length of the transition curve of same radius on road and railway, is

View solution

Q. The angle between two plane mirrors of optical square, is

View solution

Q. The latitude of a traverse leg is obtained by multiplying its length by

View solution

Q. For a curve of radius 100 m and normal chord 10 m, the Rankine's deflection angle, is

View solution

Q. A uniform slope was measured by the method of stepping. If the difference in level between two points is 1.8 m and the slope distance between them is 15 m, the error is approximately equal to

View solution

Q. Which one of the following procedures for getting accurate orientation is the most distinctive feature of the art of plane tabling

View solution

Q. A clinometer is used for

View solution

Q. Diurnal variation of magnetic declination is

View solution