Question
a.
small areas in open ground
b.
small areas with crowded details
c.
large areas with simple details
d.
large areas with difficult details.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Chain surveying is well adopted for
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. In a closed traverse, sum of south latitudes exceeds the sum of north latitudes and the sum of east departures exceeds the sum of west departures, then, the closing line will lie in
View solution
Q. A sewer is laid from a manhole A to a manhole B, 250 m away along a gradient of 1 in 125. If the reduced level of the invert at A is 205.75 m and the height of the boning rod is 3 m, the reduced level of the sight rail at B, is
View solution
Q. The Huygen's telescope eye piece
View solution
Q. The operation of resection involves the following steps
1. rough orientation of the plane table
2. the three lines form a triangle of error
3. drawing lines back through the three control points
4. select a point in the triangle of error such that each ray is equally rotated either clockwise or anti clockwise
5. the points obtained by three rays is the correct location.
The correct sequence is
View solution
Q. To avoid large centering error with very short legs, observations are generally made
View solution
Q. During secular variation of magnetic meridian at different places
View solution
Q. Designation of a curve is made by :
View solution
Q. The smaller horizontal angle between the true meridian and a survey line, is known
View solution
Q. The distance between terminal points computed from a subsidiary traverse run between them, is generally known, as
View solution
Q. For locating a distant object visible from two transit stations, the method usually preferred to, is
View solution
Q. Tacheometric formula for horizontal distances using horizontal sights can also suitable be employed for inclined sights through θ by multiplying
View solution
Q. The method of reversal
View solution
Q. You have to observe an included angle with better accuracy than what is achievable by a vernier, you will prefer the method of
View solution
Q. If the plane table is not horizontal in a direction at right angles to the alidade, the line of sight is parallel to the fiducial edge only for
View solution
Q. If the whole circle bearing of a line is 180°, its reduced bearing is
View solution
Q. The chord of a curve less than peg interval, is known as
View solution
Q. Mistakes which may produce a very serious effect upon the final results arise due to
View solution
Q. A well conditioned triangle has no angle less than
View solution
Q. Contour lines of different elevations can unite to form one line, only in the case of
View solution
Q. The line of sight is kept as high above ground surface as possible to minimise the error in the observed angles due to
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!