Question
a.
sandy soils is 80 cm to 100 cm
b.
clay soils is 90 cm to 160 cm
c.
rocky soils is 5 cm to 50 cm
d.
all the above.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. The minimum depth of building foundations on
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The ratio of the undrained strength in the undrained state to the undrained strength, at the same water content, in the remoulded state, is called the sensivity of the clay. Its value for quick clays is
View solution
Q. The total weight of a pycnometer with water and oven dried soil 20 (g) is 1600 g. The pycnometer filled with water alone weighs 1500 g. The specific gravity of the soil, is
View solution
Q. The consolidation time for soils
View solution
Q. According to IS : 2720 - 1965, the composition of a dispersing solution used in pipette analysis for determining the size of particles, is
View solution
Q. Cohesive soils are generally
View solution
Q. If the coefficient of the active pressure Ka is 1/3, the coefficient of passive pressure Kp, is
View solution
Q. The inventor of the term soil mechanics, was
View solution
Q. Compression of soil occurs rapidly if voids are filled with
View solution
Q. A saturated soil sample has water content of 40% and specific gravity of soil particles 2.7. The void ratio of the soil, is
View solution
Q. For testing a saturated clay for shear strength, the test recommended, is
View solution
Q. The critical exist gradient of seepage water in soils, increases with
View solution
Q. If drainage is permitted throughout the test, during the application of both normal, and shear stresses so that full consolidation occurs and no excess pore pressure is set up at any stage of the test, is known as
View solution
Q. A soil sample of mass specific gravity 1.92, has a moisture content 30%. If the specific gravity of solids is 2.75, the degree of saturation, is
View solution
Q. For slopes of limited extent the surface of slippage, is usually along
View solution
Q. For a base failure of a slope, depth factor
View solution
Q. A critical hydraulic gradient may occur when
View solution
Q. A clay subjected to pressure in excess to its present over-burden, is said to be
View solution
Q. The total active earth pressure due to dry back fill with no surcharge, acts at H/3 above the base of the wall and is directly proportional to
View solution
Q. Stoke's law does not hold good if the size of particle is smaller than
View solution
Q. In a purely cohesive soil, the critical centre lies at the intersection of
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!