Q. The zone in which transverse bending is likely to occur may be obtained by drawing a line from the faces of the column making an angle θ° with horizontal where θ° is

View solution

Q. If P kg/m² is the upward pressure on the slab of a plain concrete footing whose projection on either side of the wall is a cm, the depth of foundation D is given by

View solution

Q. According to load factor method, the permissible load W on a short column reinforced with longitudinal bars and lateral stirrups, is

View solution

Q. If the bearing capacity of soil is 10 tonnes/cm² and the projection of plain concrete footing from walls, is a cm, the depth D of footing is

View solution

Q. An R.C.C. lintel is spanning an opening of 2 m span in a brick wall. The height of the roof is 2.9 m above the floor level and that of the opening is 2.1 m above the floor level. The lintel is to be designed for self weight plus

View solution

Q. The pitch of the main bars in a simply supported slab, should not exceed its effective depth by

View solution

Q. In a singly reinforced beam

View solution

Q. A pre-cast pile generally used, is

View solution

Q. On an absolutely rigid foundation base, the pressure will

View solution

Q. As per IS : 456, the reinforcement in a column should not be less than

View solution

Q. The stresses developed in concrete and steel in reinforced concrete beam 25 cm width and 70 cm effective depth, are 62.5 kg/cm² and 250 kg/cm² respectively. If m = 15, the depth of its neutral axis is

View solution

Q. The angle of repose of a soil is the maximum angle which the outer face of the soil mass makes

View solution

Q. A column is regarded as long column if the ratio of its effective length and lateral dimension, exceeds

View solution

Q. Enlarged head of a supporting column of a flat slabs is technically .known as

View solution

Q. An intermediate T-beam reinforced with two layers of tensile steel with clear cover 13 cm encasted with the floor of a hall 12 metres by 7 metres, is spaced at 3 metres from adjoining beams and if the width of the beam is 20 cm, the breadth of the flange is

View solution

Q. Pick up the assumption for the design of a prestressed concrete member from the following :

View solution

Q. If the diameter of the main reinforcement in a slab is 16 mm, the concrete cover to main bars is

View solution

Q. Side face reinforcement shall be provided in the beam when depth of the web in a beam exceeds

View solution

Q. The Young's modulus of elasticity of steel, is

View solution

Q. The maximum permissible size of aggregates to be used in casting the ribs of a slab, is

View solution