Q. Stress may be defined as

View solution

Q. Total strain energy theory for the failure of a material at elastic limit, is known

View solution

Q. Stress may be expressed in Newtons

View solution

Q. Principal planes are subjected to

View solution

Q. In plastic analysis, the shape factor for a circular section, is

View solution

Q. The ratio of maximum shear stress to average shear stress of a circular beam, is

View solution

Q. A rolled steel joist is simply supported at its ends and carries a uniformly distributed load which causes a maximum deflection of 10 mm and slope at the ends of 0.002 radian. The length of the joist will be,

View solution

Q. A steel rod 1 metre long having square cross section is pulled under a tensile load of 8 tonnes. The extension in the rod was 1 mm only. If Esteel = 2 x 106 kg/cm², the side of the rod, is

View solution

Q. A compound bar consists of two bars of equal length. Steel bar cross-section is 3500 mm² and that of brass bar is 3000 mm². These are subjected to a compressive load 100,000 N. If Eb = 0.2 MN/mm² and Eb = 0.1 MN/mm², the stresses developed are:

View solution

Q. Flat spiral springs

View solution

Q. By applying the static equations i.e. ΣH = 0, ΣV = 0 and ΣM = 0, to a determinate structure, we may determine

View solution

Q. The ratio of the length and diameter of a simply supported uniform circular beam which experiences maximum bending stress equal to tensile stress due to same load at its mid span, is

View solution

Q. If a solid shaft (diameter 20 cm, length 400 cm, N = 0.8 x 10⁵ N/mm²) when subjected to a twisting moment, produces maximum shear stress of 50 N/mm², the angle of twist in radians, is

View solution

Q. The forces in the members of simple trusses, may be analysed by

View solution

Q. A simply supported beam which carries a uniformly distributed load has two equal overhangs. To have maximum B.M. produced in the beam least possible, the ratio of the length of the overhang to the total length of the beam, is

View solution

Q. At yield point of a test piece, the material

View solution

Q. A steel bar 5 m x 50 mm is loaded with 250, 000 N. If the modulus of elasticity of the material is 0.2 MN/mm² and Poisson's ratio is 0.25, the change in the volume of the bar is :

View solution

Q. A cantilever of length 2 cm and depth 10 cm tapers in plan from a width 24 cm to zero at its free end. If the modulus of elasticity of the material is 0.2 x 10⁶ N/mm², the deflection of the free end, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. A simply supported rolled steel joist 8 m long carries a uniformly distributed load over it span so that the maximum bending stress is 75 N/mm². If the slope at the ends is 0.005 radian and the value of E = 0.2 x 10⁶ N/mm², the depth of the joist, is

View solution