Q. Ryve's formula for flood estimate in cumecs, is

View solution

Q. Levees and flood walls,

View solution

Q. Pick up the correct statement from the following :

View solution

Q. The respective storm totals at three surrounding stations A, B and C are 110, 90 and 70 mm. If the normal annual precipitation amounts at stations X, A, B and C are respectively 1000, 1100, 1200 and 1250 mm, the estimated storm precipitation at X is

View solution

Q. The recurrence interval (R.I.) of 20 cm rain storm at a place is 5 years.

View solution

Q. Sharp crested weirs are generally used

View solution

Q. The area of a drainage basin whose axial length is 100 km is 2500 sq. km. Its form factor is

View solution

Q. If the axial length of a drainage basin is 35 km and its form factor is 0.2, the total area of the basin is

View solution

Q. Run off is measured in

View solution

Q. For efficient working of a control meter, its throat length is approximately kept

View solution

Q. A control meter is preferred to a weir because

View solution

Q. A river is said to be of uniform section if in its section

View solution

Q. The run off is affected by

View solution

Q. The form factor of a drainage basin is obtained by dividing

View solution

Q. Isopiastic lines are the contours

View solution

Q. The coefficients of permeability of soils of an unconfined aquifer and another confined aquifer were determined by pumping water from the wells and observing the effect of water table in two test wells at equal distances was found to be equal. The total height of confined aquifer H is given by

View solution

Q. The radius of influence is

View solution

Q. When a constant discharge 2.91 litres/sec. was obtained in a pumping test, the draw downs in the test wells at 3 m and 6.184 m were 2.6 m and 0.3 m respectively. If over-all depth of the pumping well was 16 m, the permeability of the soil, is

View solution

Q. If h is the loss due to friction in a pipe. Total losses in strainer and bends may be taken as

View solution

Q. If the loss due to friction in pipes is 4 m, the total losses in strainer and bends may be taken as

View solution