Q. Tongue plates are provided in a steel girder at

View solution

Q. The permissible stress in bending for rolled steel I-beams and channels, is

View solution

Q. Column footing is provided

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The ratio of longitudinal stress to strain within eiastic limit, is known as

View solution

Q. Web crippling generally occurs at the point where

View solution

Q. Pick up the incorrect statement from the following:

View solution

Q. The allowable stress in axial tension for rolled I-sections and channels, is taken as

View solution

Q. When a tension member is made of four angles with a plate as a web, the allowance for holes is made as

View solution

Q. The failure of a web plate takes place by yielding if the ratio of the clear depth to thickness of the web, is less than

View solution

Q. The average shear stress for rolled steel beam section, is

View solution

Q. For a rectangular section, the ratio of the maximum and average shear stresses, is

View solution

Q. To keep the intensity of bearing pressure between the column base and concrete compressive and to vary from zero to 2P/BL , the ratio of the moment M to the axial load P should be

View solution

Q. The cross-section of a standard fillet is a triangle whose base angles are

View solution

Q. Secant formula for direct stress in compression, is applicable only for slenderness ratio upto

View solution

Q. A second horizontal stiffener is always placed at the neutral axis of the girder if the thickness of the web is less than

View solution

Q. The rolled steel I-sections are most commonly used as beams because these provide

View solution

Q. The thickness t of a single flat lacing should not be less than

View solution

Q. For the steel member exposed to weather and accessible for repainting, the thickness of steel should not be less than (excepting the webs of Indian Standard rolled steel joists and channels).

View solution

Q. Live load

View solution