Question
a.
When the gauge distance is larger than the pitch, the failure of the section may occur in a zig-zag line
b.
When the gauge distance is smaller than the pitch, the failure of the section may occur in a straight right angle section through the centre of rivet holes
c.
When the gauge distance and pitch are both equal, the failure to the section becomes more likely as the diameter of the holes increases
d.
All the above.
Posted under Civil Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Pick up the correct statement from the following:
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. The ratio of longitudinal stress to strain within eiastic limit, is known as
View solution
Q. Web crippling generally occurs at the point where
View solution
Q. Pick up the incorrect statement from the following:
View solution
Q. The allowable stress in axial tension for rolled I-sections and channels, is taken as
View solution
Q. When a tension member is made of four angles with a plate as a web, the allowance for holes is made as
View solution
Q. The failure of a web plate takes place by yielding if the ratio of the clear depth to thickness of the web, is less than
View solution
Q. The average shear stress for rolled steel beam section, is
View solution
Q. For a rectangular section, the ratio of the maximum and average shear stresses, is
View solution
Q. To keep the intensity of bearing pressure between the column base and concrete compressive and to vary from zero to 2P/BL , the ratio of the moment M to the axial load P should be
View solution
Q. The cross-section of a standard fillet is a triangle whose base angles are
View solution
Q. Secant formula for direct stress in compression, is applicable only for slenderness ratio upto
View solution
Q. A second horizontal stiffener is always placed at the neutral axis of the girder if the thickness of the web is less than
View solution
Q. The rolled steel I-sections are most commonly used as beams because these provide
View solution
Q. The thickness t of a single flat lacing should not be less than
View solution
Q. For the steel member exposed to weather and accessible for repainting, the thickness of steel should not be less than (excepting the webs of Indian Standard rolled steel joists and channels).
View solution
Q. Live load
View solution
Q. The most economical section for a column, is
View solution
Q. If the depth of two column sections are equal, then the column splice is provided
View solution
Q. The distance between e.g. of compression and e.g. of tension flanges of a plate girder, is known as
View solution
Q. The effective length of a compression member of length L held in position and restrained in direction at one end and effectively restrained in direction but not held in position at the other end, is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Civil Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
