Q. For concreting of shallow sections with vibration, the work ability of concrete should be

View solution

Q. The slenderness effect of a wall is considered if the effective height of the wall exceeds the thickness

View solution

Q. For achieving suitably a low permeability

View solution

Q. Minimum thickness of steel work directly exposed to weather and accessible for cleaning and repainting, the thickness should be not less than

View solution

Q. In limit state method, the design bond stress of M 30 grade concrete for plain bars in tension, is

View solution

Q. If the end of a beam of span L carrying a designed load W is partially restrained by a built up wall, it is designed to resist the negative moment at the face of the support, equal to

View solution

Q. Generally acceptable nominal size of aggregates for reinforced concrete, is

View solution

Q. Moist sand may contain surface water by mass upto

View solution

Q. The minimum horizontal distance between two parallel main reinforcing bars, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The spans of filler joists supporting a slab may be considered approximately equal if the longest span does not exceed the shortest span more than

View solution

Q. Removal of props under

View solution

Q. To achieve uniform colour and consistency of the concrete by using ordinary Portland cement, the mixing time may be

View solution

Q. For the proportions

View solution

Q. Columns are designed for a minimum eccentricity equal to 1/30 (unsupported length ofthe column), subject to a minimum of

View solution

Q. If fck is the characteristic cube strength of concrete in N/mm², the modulus of elasticity of structural concrete Ec = a√fck where the value of a, is

View solution

Q. The effective depth of a shallow beam is the distance between

View solution

Q. The minimum area of cross section of reinforcement in either direction of a slab should not be less than ...... of the slab cross section

View solution

Q. Pick up the correct statement from the following:

View solution