Q. In limit state method, the design bond stress of M 30 grade concrete for plain bars in tension, is

View solution

Q. If the end of a beam of span L carrying a designed load W is partially restrained by a built up wall, it is designed to resist the negative moment at the face of the support, equal to

View solution

Q. Generally acceptable nominal size of aggregates for reinforced concrete, is

View solution

Q. Moist sand may contain surface water by mass upto

View solution

Q. The minimum horizontal distance between two parallel main reinforcing bars, is

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Pick up the correct statement from the following:

View solution

Q. The spans of filler joists supporting a slab may be considered approximately equal if the longest span does not exceed the shortest span more than

View solution

Q. Removal of props under

View solution

Q. To achieve uniform colour and consistency of the concrete by using ordinary Portland cement, the mixing time may be

View solution

Q. For the proportions

View solution

Q. Columns are designed for a minimum eccentricity equal to 1/30 (unsupported length ofthe column), subject to a minimum of

View solution

Q. If fck is the characteristic cube strength of concrete in N/mm², the modulus of elasticity of structural concrete Ec = a√fck where the value of a, is

View solution

Q. The effective depth of a shallow beam is the distance between

View solution

Q. The minimum area of cross section of reinforcement in either direction of a slab should not be less than ...... of the slab cross section

View solution

Q. Pick up the correct statement from the following:

View solution

Q. Pick up the correct statement for the web stiffeners.

View solution

Q. The structure which is subjected to an imposed load after 72 hours for a period of 24 hours, is deemed to be unacceptable if it fails to recover the net deflection less than

View solution

Q. The pitch of transverse reinforcement of a column is taken as

View solution

Q. The pH value of water to be used in concrete shall generally be

View solution