Question

Pick the correct statement with respect to following figure.

a.

both the circuit are not identical filter Ckts

b.

identical filter circuit at all frequencies

c.

identical filter circuit at low frequency

d.

identical filter circuit at high frequency

Answer: (c).identical filter circuit at low frequency

Interact with the Community - Share Your Thoughts

Uncertain About the Answer? Seek Clarification Here.

Understand the Explanation? Include it Here.

Q. Pick the correct statement with respect to following figure.

Similar Questions

Explore Relevant Multiple Choice Questions (MCQs)

Q. A series RL circuit is switched on to an impulse. A δ(t) at t = 0. Then

Q. In figure, the switch is initially open. At t = 0 switch is closed. vc (0+) and iL (0+) are

Q. Consider the following two statements:

Q. For the network of figure, [z] matrix is

Q. Which one of the following parameters does not exist for the two port network shown in the given figure?

Q. For the circuit of figure, the time constant is

Q. A pole zero plot of a filter is shown in figure. It is

Q. In an idealized half wave rectified system the average and r.m.s. values of voltage are __________ respectively.

Q. Which of the following is correct? The circuit shown in the figure.

1. is reciprocal but not symmetrical
2. is not reciprocal but symmetrical
3. both reciprocal and symmetrical
4. neither reciprocal nor symmetrical

Q. For an m-derived high pass filter

Q. In figure, the switch has been in closed position for a long time. At t = 0, the switch is opened. At t = 0+, the current R1 is

Q. The expression for the resonant frequency ω0 in the circuit shown

Q. For a superconductor, magnetisation M in a field H is

Q. A sinusoidal voltage has peak to peak value of 100 V. The rms value is

Q. A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be

Q. RMS value of i(t) = 10[1 + sin (- t)] is

Q. The electrical energy required to heat a bucket of water to a certain temperature is 2 kWh. If heat losses, are 25%, the energy input is

Q. The current rating of a cable depends on

Q. In an ac circuit, the maximum and minimum values of power factor can be

Q. A cable has an insulation resistance of 10¹ᴼ ohms. If the length is doubled, the insulation resistance will be

Recommended Subjects

Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.

Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!