Question
a.
Both A and R are true and R is correct explanation of A
b.
Both A and R are true and R is not the correct explanation of A
c.
A is true but R is false
d.
A is false but R is true
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Consider the following two statements:
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. For the network of figure, [z] matrix is
View solution
Q. Which one of the following parameters does not exist for the two port network shown in the given figure?
View solution
Q. For the circuit of figure, the time constant is
View solution
Q. A pole zero plot of a filter is shown in figure. It is
View solution
Q. In an idealized half wave rectified system the average and r.m.s. values of voltage are __________ respectively.
View solution
Q. Which of the following is correct? The circuit shown in the figure.
1. is reciprocal but not symmetrical
2. is not reciprocal but symmetrical
3. both reciprocal and symmetrical
4. neither reciprocal nor symmetrical
View solution
Q. For an m-derived high pass filter
View solution
Q. In figure, the switch has been in closed position for a long time. At t = 0, the switch is opened. At t = 0+, the current R1 is
View solution
Q. The expression for the resonant frequency ω0 in the circuit shown
View solution
Q. For a superconductor, magnetisation M in a field H is
View solution
Q. A sinusoidal voltage has peak to peak value of 100 V. The rms value is
View solution
Q. A capacitor is needed for an ac circuit of 230 V, 50 Hz the peak voltage rating of the capacitor should be
View solution
Q. RMS value of i(t) = 10[1 + sin (- t)] is
View solution
Q. The electrical energy required to heat a bucket of water to a certain temperature is 2 kWh. If heat losses, are 25%, the energy input is
View solution
Q. The current rating of a cable depends on
View solution
Q. In an ac circuit, the maximum and minimum values of power factor can be
View solution
Q. A cable has an insulation resistance of 10¹ᴼ ohms. If the length is doubled, the insulation resistance will be
View solution
Q. Which of the following pairs are correctly matched?
1. Brune's realisation : realisation with ideal transformer.
2. Cauer realisation : ladder realisation.
3. Bott Duffin realisation : with non ideal transformer.
Select the answer using the following codes:
View solution
Q. The synthesis of minimum function was suggested by
View solution
Q. For a transmission line open circuit and short circuit impedances are 20 Ω and 5 Ω. Then characteristic impedance is
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!