Q. In figure VBE = 0.7 V. The base current is

View solution

Q. The circuit in the given figure is

View solution

Q. A bridge diode circuit using ideal diodes has in input voltage of 20 sin ωt volts. The average and rms values of output voltage are

View solution

Q. In the circuit of figure v1 = 8 V and v2 = 0. Which diode will conduct (Assume ideal diodes)?

View solution

Q. In the circuit of figure β = 100 and quiescent value of base current is 20 μA. The quiescent value of collector

View solution

Q. In figure which diode will conduct and what will be the value of V0?

View solution

Q. For the amplifier circuit of figure, the h parameters of transistor are hib = 25 Ω, hfb = 0.999, hob = 10¯⁶ Ω. The voltage gain is

View solution

Q. In figure, VCC = + 30 V, R1 = 200 kΩ and R2 = 100 kΩ. If VBE = 0.7 V, the voltage a cross RE =

View solution

Q. The Vo of the op-amp circuit shown in the given is

View solution

Q. In figure base current is 10 μA and βdc = 100. Then VE =

View solution

Q. In the figure, assume the op-amp is to be ideal. The output Vo if the circuit is

View solution

Q. Assuming VCE sat = 0.2 V and β = 50, the minimum base current (IB) required to drive the transistor in the given figure to saturation is

View solution

Q. In the op-amp circuit given in the figure, the load current iL is

View solution

Q. In figure, secondary winding has 40 turns. For maximum power transformer to 2 ohm resistance the number of turns in primary is

View solution

Q. In figure if the transistor is cut off, the collector voltage is equal to

View solution

Q. In figure, D1 turns on when

View solution

Q. In the circuit of figure both diodes are ideal. If v1 = 10 V and v2 = 10 V which diode will conduct?

View solution

Q. In the circuit of the given figure, assume that the diodes are ideal and the meter is an average indicating ammeter, the ammeter will read

View solution

Q. In the following figure C = 0.02 μF, and Vth is known to be of frequency ω = 10⁷ rad/sec and rd = 2.5 Ω and ZTh = RTh = 10 Ω Then phase angle between id and Vd

View solution

Q. In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles are

View solution