Q. In figure, secondary winding has 40 turns. For maximum power transformer to 2 ohm resistance the number of turns in primary is

View solution

Q. In figure if the transistor is cut off, the collector voltage is equal to

View solution

Q. In figure, D1 turns on when

View solution

Q. In the circuit of figure both diodes are ideal. If v1 = 10 V and v2 = 10 V which diode will conduct?

View solution

Q. In the circuit of the given figure, assume that the diodes are ideal and the meter is an average indicating ammeter, the ammeter will read

View solution

Q. In the following figure C = 0.02 μF, and Vth is known to be of frequency ω = 10⁷ rad/sec and rd = 2.5 Ω and ZTh = RTh = 10 Ω Then phase angle between id and Vd

View solution

Q. In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles are

View solution

Q. In figure, VG =

View solution

Q. In figure the voltage drop across diode is 0.7 V. Then the voltage across diode during negative half cycle is

View solution

Q. In figure vi = 10 mV dc maximum. The maximum possible dc output offset voltage is

View solution

Q. For the circuit of figure the critical frequency is

View solution

Q. The current through R1 is(If β = 99, VBE = 0.74 V)

View solution

Q. The feedback technique employed in the following circuit is

View solution

Q. In figure the approximate voltages of

View solution

Q. Which one of the following is connect expression of id for figure?

View solution

Q. In figure the current through resistor R

View solution

Q. For an npn transistor connected as shown in the figure VBE = 0.7 volts. Given that reverse saturation current of the junction at room temperature 300K is 10¯¹³A, the emitter current.

View solution

Q. The dc output voltage of the circuit is

View solution

Q. In figure we need an ac ground. The proper value of C is

View solution

Q. For the circuit in figure the output wave shape is

View solution