Q. In figure V0 =

View solution

Q. In figure, ID = 4 mA. Then VS =

View solution

Q. The circuit shown is

View solution

Q. The zener diode in the rectangular circuit shown in the figure has a zener voltage of 5.8 volts and a zener knee current of 0.5 mA. The maximum load current drawn from this circuit ensuring proper functioning over the input voltage range between 20 and 30 volts, is

View solution

Q. In figure, ID = 4 mA. Then VDS =

View solution

Q. In figure, V0 =

View solution

Q. In the circuit of figure diode will conduct

View solution

Q. In figure, V0 =

View solution

Q. The JFET in the circuit shown in figure has an IDSS = 10 mA and Vp = -5V. The value of the resistance Rs for a drain current IDS = 6.4 mA is

View solution

Q. In figure, V0 =

View solution

Q. In the op-amp circuit of figure, V0 =

View solution

Q. In figure the zener has a resistance of 5 ohms. As the load resistance is varied, the output voltage

View solution

Q. The transistor of following figure in Si diode with a base current of 40 μA and ICBO = 0, if VBB = 6V, RE = 2 kΩ and β = 90, IBQ = 20 μA then IEQ =

View solution

Q. In the CE circuit shown in figure the slope of ac load line will be

View solution

Q. The op-amp circuit shown in the figure is a filter. The type of filter and its cut off type of filter and its cut off frequency are respectively.

View solution

Q. In the circuit of figure, PIV can be up to

View solution

Q. In the circuit of figure β = 50 and VBE = 0.5 V. The quiescent value of base current IB is

View solution

Q. In figure the input and output Miller capacitances are

View solution

Q. Figure uses 10 V zener diode. The minimum and maximum current through series resistance are

View solution

Q. When Z1 << Z, The circuit of figure works as

View solution