Q. The frequency response of an ideal tuned amplifier should be as represented in figure by

View solution

Q. In figure vi is a sinusoidal wave. Which of the following best describes the output v0?

View solution

Q. For an amplifier the input output signals are shown in figure. The class of amplifier is

View solution

Q. The oscillator shown in figure is a

View solution

Q. Figure represents a

View solution

Q. The circuit in figure is

View solution

Q. In order to obtain triangular pulses at the output of the circuit in the figure, the input should be.

View solution

Q. The circuit in figure is

View solution

Q. The oscillator shown in figure is a

View solution

Q. For an I/p of Vs = 5 sin ωt (assuming ideal diode), circuit shown in the figure will behave as a

View solution

Q. In figure

View solution

Q. In a Hartley oscillator the condition for sustained oscillations is hfe = L₁/L₂ . If there exists mutual inductance M between coils L₁ and L₂, then the above condition will get modified as hfe

View solution

Q. Figure shows current pulses of a class C power amplifier. The fundamental frequency of these pulses is

View solution

Q. The Clapp oscillator shown in figure will operate at

View solution

Q. Figure shows a zener circuit and characteristic of the zener used. If R2 is the lowest load resistance, then for proper voltage regulation R1 must be

View solution

Q. In figure, VC is approximately equal to

View solution

Q. Figure shows small signal model of CB amplifier circuit. Then I and R are respectively equal to

View solution

Q. Figure represents a

View solution

Q. In figure VBE = 0.7 V. If base current required to saturate the transistor is 0.1 mA, Vi =

View solution

Q. As per miller theorem the circuit of figure (1) can be replaced by that in figure (2) If V1/V2 = K, then Y1 and Y2 are equal to

View solution