Q. For a BJT, β and a are related as

View solution

Q. The circuit diagram shown in the figure consists of transistors in

View solution

Q. The circuit of figure is called

View solution

Q. In the equivalent circuit of figure voltage gain is

View solution

Q. Figure represents a

View solution

Q. In a closed loop non-inverting amplifier, constructed using single break-frequency op-amp, bandwidth with feedback can be written as. (f0 - break frequency, β - gain of the feedback circuit, A - open loop voltage gain, Af - closed loop voltage gain)

View solution

Q. Two identical FETs, each characterised by the parameters gm and rd are connected in parallel. The composite FET is then characterised by the parameters

View solution

Q. DC voltage of the order of a few mV can be accurately of measured by

View solution

Q. In a CE amplifier the input impedance is equal to the ratio of

View solution

Q. For a system to work, as oscillator the total phase shift of the loop gain must be equal to

View solution

Q. An amplifier has a large ac input signal. The clipping occurs on both the peaks. The output voltage will be nearly a

View solution

Q. To prevent a DC return between source and load, it is necessary to use

View solution

Q. For a base current of 10 μA, what is the value of collector current in common emitter if βdc = 100

View solution

Q. Which of the following oscillators is suitable for frequencies in the range of mega hertz?

View solution

Q. Consider the following statements : A clamper circuit

1. adds or subtracts a dc voltage to a waveform
2. does not change the waveform
3. amplifiers the waveform

Which are correct?

View solution

Q. A forward voltage of 9 V is applied to a diode in series with a 1 kΩ load resistor. The voltage across load resistor is zero. It indicates that

View solution

Q. Which power amplifier can deliver maximum load power?

View solution

Q. The quiescent collector current IC, and collector to emitter voltage VCE in a CE connection are the values when

View solution

Q. An exponential amplifier has diode in feedback path.

View solution

Q. DC amplifiers have a tendency to be unstable.

View solution