Q. The given figure shows dB magnitude plots for type 0, type 1 and type 2 systems. Out of these

View solution

Q. For the given figure, the transfer function X(s)/P(s) =

View solution

Q. In the given figure shows a root locus plot. Consider the following statements for this plot

1. The open loop system is a second order system
2. The system is overdamped for K > 1
3. The system is stable for all values of K

Which of the above statements are correct?

View solution

Q. In the given figure the number of combinations of three non touching loops is

View solution

Q. In the given figure, the curves 1, 2, 3 are respectively for

View solution

Q. In the given figure, the number of individual loops is

View solution

Q. The block diagram of the given figure for

View solution

Q. The radius and centre of M circles are given by

View solution

Q. For the system in the given figure the root locus

View solution

Q. A system has two poles as shown in the given figure. The zeros are at infinity. If input is unit step, the steady state output is

View solution

Q. A unity feedback system has the following open loop frequency response. The gain margin and phase margin are

View solution

Q. For the system in the given figure, the gain margin is

View solution

Q. In the signal flow graph in the given figure the number of forward paths and pairs of non-touching loops are respectively

View solution

Q. In an armature controlled dc motor let J be equivalent moment of inertia of motor and load, f0 be equivalent viscous friction coefficient of motor and load and θ be angular displacement of motor shaft. Then torque equation is

View solution

Q. Consider the following statement:

View solution

Q. The system of the given figure

View solution

Q. For a feedback system given below, the velocity error constant Kv is given by

View solution

Q. If G(s)H(s) is given by following equation, the closed loop pole will be located at s = -12 when K =

View solution

Q. In the given figure, the combinations of two non touching loops is

View solution

Q. For the system in the given figure G varies slightly, the ratio of open loop sensitivity to closed loop sensitivity is

View solution