Q. A sinusoidal signal is measured by CRO. The scale is set at 4 mV/cm. If vertical distance between positive and negative peaks is 6 cm, the peak value of ac signal is

View solution

Q. Wheatstone bridge is suitable for low resistances.

View solution

Q. To avoid creep in an energy meter

View solution

Q. A wire strain gauge has a gauge factor of 2, resistance of 125 Ω and length 1 m. If length of wire changes by .005 m, change in resistance will be

View solution

Q. Four voltmeters have following specifications. If accuracy is main consideration which is the best?

View solution

Q. The deflection of a DArsonval galvanometer is measured through a mirror and scale. The mirror is 1 m away from the light source. The mirror is mounted on, the moving system. If mirror rotates through 0.2 rad the displacement on the scale is

View solution

Q. Two ammeters having resistances of 0.5 Ω and 0.25 Ω and having full scale reading of 25 A each are connected in parallel. To ensure that neither of them goes beyond scale, the total current should not be more than

View solution

Q. A polyphase wattmeter basically consists of two wattmeters. The moving system of two wattmeters

View solution

Q. The dead zone in a pyrometer is 0.125% of span. The calibration is 400°C to 1000°C. What temperature change might occur before it is detected.

View solution

Q. The dimensions of force are

View solution

Q. A 1 mA meter is to be converted to 1 A ammeter. The meter resistance is 100 Ω. The value of shunt resistance is

View solution

Q. The use of thermocouple meters for ac measurement leads to a scale which is

View solution

Q. Assertion (A): A low power factor wattmeter has special constructional features to ensure accurate measurement.

Reason (R): Extension of wattmeter range in dc circuit can be easily done by using current and potential transformer.

View solution

Q. The scale of dynamometer wattmeter is non linear.

View solution

Q. Magnetic deflection is inversely proportional to

View solution

Q. The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be

View solution

Q. If the secondary burden of a CT 15 VA and secondary current is 5 A, the load impedance of CT is

View solution

Q. Consider the following instruments

1. Tangent galvanometer
2. Rayleigh current balance
3. Household energy meter
4. Hot wire ammeter

Out of above absolute instruments are

View solution

Q. A 0-150 voltmeter has a guaranteed accuracy of 1% of full scale reading. If actual reading is 83 V, the percentage error is

View solution

Q. In a CRO, the frequency of output of time base generator

View solution