Q. A 0-150 voltmeter has a guaranteed accuracy of 1% of full scale reading. If actual reading is 83 V, the percentage error is

View solution

Q. In a CRO, the frequency of output of time base generator

View solution

Q. If A = 131 ± 4 and B = 106 ± 4, the percentage range of doubt in A - B is

View solution

Q. Two resistance R1 and R2 are connected in series R1 = 528 ± 5 Ω and R2 = 325 ± 3Ω. The total resistance will be

View solution

Q. The function of shunt in an ammeter is to

View solution

Q. Which of the following does not use the principle of change in inductance?

View solution

Q. It is necessary to measure the amplitudes of two signals and also the phase difference between them. This can be done by using a

View solution

Q. An amplifier has to amplify pulses of 1 H-s duration. The minimum bandwidth of amplifier must be

View solution

Q. A moving coil meter has a resistance of 50 ohms and a full scale deflection current of 20 mA. To convert it into a voltmeter of 0-100 V range, the series resistance should be

View solution

Q. In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected

View solution

Q. Which of the following methods can be used to measure power in a single phase circuit without using wattmeter?

1. One voltmeter, one ammeter
2. Two voltmeters, two ammeter
3. Three voltmeters
4. Three ammeters

View solution

Q. For measurement of surface temperature of solids the elements of RTD is usually in the shape of

View solution

Q. As per BIS, the number of accuracy classes of instrument is

View solution

Q. In most of instruments, the controlling torque is provided by

View solution

Q. A 0-200 V voltmeter has a sensitivity of 1 kΩ per volt. The resistance of voltmeter is

View solution

Q. DC ampere hour meter is an indicating instrument.

View solution

Q. The accuracy of measurement by ohmmeter is very good.

View solution

Q. The resistance in the circuit of the moving coil of a dynamometer wattmeter should be

View solution

Q. A temperature sensistive transducer is subjected to sudden temperature change. It takes 10 seconds for transducer to reach equilibrium condition (five times time constant). The time taken to reach half of temperature difference will be

View solution

Q. The most commonly used moving iron instruments are

View solution