Q. Which of the following methods can be used to measure power in a single phase circuit without using wattmeter?

1. One voltmeter, one ammeter
2. Two voltmeters, two ammeter
3. Three voltmeters
4. Three ammeters

View solution

Q. For measurement of surface temperature of solids the elements of RTD is usually in the shape of

View solution

Q. As per BIS, the number of accuracy classes of instrument is

View solution

Q. In most of instruments, the controlling torque is provided by

View solution

Q. A 0-200 V voltmeter has a sensitivity of 1 kΩ per volt. The resistance of voltmeter is

View solution

Q. DC ampere hour meter is an indicating instrument.

View solution

Q. The accuracy of measurement by ohmmeter is very good.

View solution

Q. The resistance in the circuit of the moving coil of a dynamometer wattmeter should be

View solution

Q. A temperature sensistive transducer is subjected to sudden temperature change. It takes 10 seconds for transducer to reach equilibrium condition (five times time constant). The time taken to reach half of temperature difference will be

View solution

Q. The most commonly used moving iron instruments are

View solution

Q. A moving iron instrument can be used for

View solution

Q. Two voltmeters are each 0-300 V range. Their internal resistances are 10 kΩ and 20 kΩ They are connected is series and a voltage of 400 V is applied. Their readings respectively will be

View solution

Q. A 300 V voltmeter has an accuracy of ± 2% of full scale deflection. When the reading is 222 V, the actual voltage

View solution

Q. In a thermocouple two metal junctions between metals M1 and M2 are kept at temperature T1 and T2. The thermocouple emf is produced because

View solution

Q. Hay's bridge is suitable for inductances having low L/R ratio.

View solution

Q. Moving iron instrument can be used for ac only.

View solution

Q. In electronic voltmeters the measuring device is a

View solution

Q. An ammeter has a resistance of 50 ohms and a shunt of 0.01 Ω. The deflection is θ. If the shunt resistance is increased to 0.02 Ω, the deflection will be.

View solution

Q. Assertion (A): Double Kelvin's bridge is used to measure low resistances.

Reason (R): In low resistance, the contact and lead resistances are very important.

View solution

Q. Shaft encoder is used to measure

View solution