Q. The dimensions of force are

View solution

Q. A 1 mA meter is to be converted to 1 A ammeter. The meter resistance is 100 Ω. The value of shunt resistance is

View solution

Q. The use of thermocouple meters for ac measurement leads to a scale which is

View solution

Q. Assertion (A): A low power factor wattmeter has special constructional features to ensure accurate measurement.

Reason (R): Extension of wattmeter range in dc circuit can be easily done by using current and potential transformer.

View solution

Q. The scale of dynamometer wattmeter is non linear.

View solution

Q. Magnetic deflection is inversely proportional to

View solution

Q. The current passing through a resistance of 100 ± 0.2% Ω is 2 ± 0.5% A. The limiting error in computation of power will be

View solution

Q. If the secondary burden of a CT 15 VA and secondary current is 5 A, the load impedance of CT is

View solution

Q. Consider the following instruments

1. Tangent galvanometer
2. Rayleigh current balance
3. Household energy meter
4. Hot wire ammeter

Out of above absolute instruments are

View solution

Q. A 0-150 voltmeter has a guaranteed accuracy of 1% of full scale reading. If actual reading is 83 V, the percentage error is

View solution

Q. In a CRO, the frequency of output of time base generator

View solution

Q. If A = 131 ± 4 and B = 106 ± 4, the percentage range of doubt in A - B is

View solution

Q. Two resistance R1 and R2 are connected in series R1 = 528 ± 5 Ω and R2 = 325 ± 3Ω. The total resistance will be

View solution

Q. The function of shunt in an ammeter is to

View solution

Q. Which of the following does not use the principle of change in inductance?

View solution

Q. It is necessary to measure the amplitudes of two signals and also the phase difference between them. This can be done by using a

View solution

Q. An amplifier has to amplify pulses of 1 H-s duration. The minimum bandwidth of amplifier must be

View solution

Q. A moving coil meter has a resistance of 50 ohms and a full scale deflection current of 20 mA. To convert it into a voltmeter of 0-100 V range, the series resistance should be

View solution

Q. In measuring a resistance by voltmeter-ammeter method, the voltmeter can be connected either across supply or across the resistance. If the resistance is low, the voltmeters should be connected

View solution

Q. Which of the following methods can be used to measure power in a single phase circuit without using wattmeter?

1. One voltmeter, one ammeter
2. Two voltmeters, two ammeter
3. Three voltmeters
4. Three ammeters

View solution