Q. The resistance of series field winding is a low resistance.

View solution

Q. The torque in induction wattmeters due to

View solution

Q. During testing of an energy meter, the energy recorded by meter was 0.05 kWh and correct energy was found to be 0.09 kWh. The error and correction respectively are

View solution

Q. Two resistances are : R1 = 36 Ω ± 1.89 Ω and R2 = 75 Ω ± 3.75 Ω. The sum R1 + R2 along with limiting error is

View solution

Q. An instrument of accuracy class 1 can have an error equal to

View solution

Q. An induction wattmeter can be used for ac only.

View solution

Q. To measure a resistance of about 8 ohms we should use

View solution

Q. For measuring temperatures below 800°C with high accuracy, the best instrument is

View solution

Q. Panel instruments are generally mounted vertically.

View solution

Q. Assertion (A): Many instruments use eddy current damping.

Reason (R): Eddy currents set up a magnetic flux which opposes the original movement which generates them.

View solution

Q. A generated voltage is equally dependent on three resistances R1, R2, R3 and its value is V = (R1R2)/R3. If tolerance of each resistor is 0.1%, the maximum error in voltage is

View solution

Q. Assertion (A): A thermocouple transducer is based on Seeback effect.

Reason (R): In a thermocouple transducer used for temperature measurement, the cold junction is usually kept in ice bath.

View solution

Q. In an Anderson bridge the unknown inductance is measured in terms of

View solution

Q. In a Ballistic galvanometer

View solution

Q. Which instrument needs creep compensation?

View solution

Q. For use at 50 Hz the range of scale of vibrating reed frequency meter is

View solution

Q. Consider the following statements about a moving iron instrument

1. It is an unpolarised instrument.
2. It has permanent magnet.
3. It has a fixed coil.
4. It has two iron vanes.

Of these statements

View solution

Q. The two pressure coils in a single phase power factor meter of turns

View solution

Q. Piezoelectric effect can be used to measure

View solution

Q. A current of 3.18 A is flowing through resistance of 35.68 Ω. The voltage drop across resistance to the appropriate number of significant figures is

View solution