Q. A power factor meter has

View solution

Q. In a semiconductor strain gauge, the ohmic electrical contacts are generally made of

View solution

Q. To measure dielectric loss you would use

View solution

Q. Minute cracks in metals and minute faults in welded joints can be detected using

View solution

Q. Which of these instruments has highest power consumption?

View solution

Q. If A = 629 ± 8 and B = 131 ± 3, A - B with range of doubt is

View solution

Q. Assertion (A): If the reading of an instrument is low, the error is large.

Reason (R): The error of an instrument is certain percentage of its full scale deflection.

View solution

Q. A thermocouple instrument can be used over a very wide frequency range.

View solution

Q. A vibration galvanometer is a

View solution

Q. A megger has a hand driven dc generator.

View solution

Q. A hot wire instrument is not affected by stray magnetic fields.

View solution

Q. Assertion (A): A ballistic galvanometer is used to measure charge.

Reason (R): In a flux meter, the damping is large.

View solution

Q. Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.

Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.

View solution

Q. Acoustic strain gauges

View solution

Q. Which of these instruments is dynamometers type?

View solution

Q. The instrument used to check insulation of household wiring is

View solution

Q. Watthour meter is an integrating instrument

View solution

Q. An ammeter is

View solution

Q. It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is

View solution

Q. Assertion (A): When frequencies of signals fed to X and Y plates of CRO are multiples of each other, Lissajous pattern is displayed on screen.

Reason (R): In a CRO, the vertical deflection is proportional to voltage applied to Y plates.

View solution