Question
a.
IR rays
b.
UV rays
c.
a rays
d.
X-ray/γ-rays
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Minute cracks in metals and minute faults in welded joints can be detected using
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which of these instruments has highest power consumption?
View solution
Q. If A = 629 ± 8 and B = 131 ± 3, A - B with range of doubt is
View solution
Q. Assertion (A): If the reading of an instrument is low, the error is large.
Reason (R): The error of an instrument is certain percentage of its full scale deflection.
View solution
Q. A thermocouple instrument can be used over a very wide frequency range.
View solution
Q. A vibration galvanometer is a
View solution
Q. A megger has a hand driven dc generator.
View solution
Q. A hot wire instrument is not affected by stray magnetic fields.
View solution
Q. Assertion (A): A ballistic galvanometer is used to measure charge.
Reason (R): In a flux meter, the damping is large.
View solution
Q. Assertion (A): A transducer needs an output measuring or display device for measuring a non electrical quantity.
Reason (R): In some transducers the output voltage is too small and needs amplification before it can be measured.
View solution
Q. Acoustic strain gauges
View solution
Q. Which of these instruments is dynamometers type?
View solution
Q. The instrument used to check insulation of household wiring is
View solution
Q. Watthour meter is an integrating instrument
View solution
Q. An ammeter is
View solution
Q. It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is
View solution
Q. Assertion (A): When frequencies of signals fed to X and Y plates of CRO are multiples of each other, Lissajous pattern is displayed on screen.
Reason (R): In a CRO, the vertical deflection is proportional to voltage applied to Y plates.
View solution
Q. In portable instruments, damping is provided by
View solution
Q. The sensitivity of electromagnetic digital flow meter can be increased by increasing
View solution
Q. The increase in intensity of trace in a CRO causes a change in
View solution
Q. A diode peak reading VTVM and thermocouple meter are connected across output of an amplitude modulated circuit. In the absence of modulation both meters read 10 V. When sinusoidal AM is applied, VTVM reads 15V The reading of thermocouple meter will be
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
