Q. If Ey is the voltage applied to Y plates, the vertical deflection of beam is proportional to

View solution

Q. The method of frequency compensation in moving iron voltmeter is

View solution

Q. A moving iron instrument has

View solution

Q. The temperature coefficient of resistance for a thermistor is

View solution

Q. To measure an unknown ac voltage by an ac potentiometer it is desirable that supply for the potentiometer is taken

View solution

Q. A linear displacement digital transducer generally uses

View solution

Q. Two wattmeter method for 3 phase power measurement can be used only for

View solution

Q. A coil resonates at 1 MHz with a resonating capacitance of 72 pF. At 500 pF, resonance is obtained with a resonating capacitor of 360 pF. The self capacitance of coil is

View solution

Q. A peak responding ac voltmeter using a half wave rectifier has been calibrated to read 1 V for 1 V rms sine wave input. If input is 1 V dc the reading will be

View solution

Q. For measuring inductance with high Q, we should use

View solution

Q. A resistance strain gauge has a resistance of about

View solution

Q. Crompton potentiometer has

View solution

Q. Assertion (A): For best results the system of a D'Arsonval galvanometer should be slightly under damped.

Reason (R): Degree of damping affects the time taken by the instrument to come to final position.

View solution

Q. Assertion (A): An RTD uses platinum coil.

Reason (R): Platinum is a very stable material.

View solution

Q. Which of the following, is not a piezoelectric material?

View solution

Q. Harmonic distortion analyser

View solution

Q. An electrostatic voltmeter is suitable for

View solution

Q. The flow rate of electrically conducting liquid without any suspended particle can not be measured by

View solution

Q. While calibrating an ammeter by a dc potentiometer it is necessary to use a standard resistance.

View solution

Q. The term 'Poisson's ratio' is connected with

View solution