Question
Reason (R): Platinum is a very stable material.
a.
Both A and R are true and R is correct explanation of A
b.
Both A and R are true but R is not correct explanation of A
c.
A is true R is false
d.
A is false R is true
Posted under Electronics and Communication Engineering
Interact with the Community - Share Your Thoughts
Uncertain About the Answer? Seek Clarification Here.
Understand the Explanation? Include it Here.
Q. Assertion (A): An RTD uses platinum coil. Reason (R): Platinum is a very stable material.
Similar Questions
Explore Relevant Multiple Choice Questions (MCQs)
Q. Which of the following, is not a piezoelectric material?
View solution
Q. Harmonic distortion analyser
View solution
Q. An electrostatic voltmeter is suitable for
View solution
Q. The flow rate of electrically conducting liquid without any suspended particle can not be measured by
View solution
Q. While calibrating an ammeter by a dc potentiometer it is necessary to use a standard resistance.
View solution
Q. The term 'Poisson's ratio' is connected with
View solution
Q. A direct current can be measured
View solution
Q. Consider the following galvanometers
1. D'Arsonval
2. Ballistic
3. Vibration
Which of these are permanent magnet moving coil instruments?
View solution
Q. Assertion (A): Hall effect is observed in all metals but is very appreciable in semiconductors.
Reason (R): Hall effect transducer is very suitable for measurement of magnetic flux density.
View solution
Q. Assertion (A): The trigger circuit of a CRO is excited by the same signal as Y plates.
Reason (R): The time base generator develops a saw tooth voltage.
View solution
Q. A data signal having frequency components from dc to 50 Hz is to be sent through pulse code modulation using an 8 digit code. The minimum carrier channel bandwidth is
View solution
Q. The material used in RTD is
View solution
Q. Basically a potentiometer is a device for
View solution
Q. It is required to measure the true open circuit emf of a battery. The best device is
View solution
Q. If two time varying signals of equal magnitudes and 90° phase displacement are applied to X and Y plates of CRO, the display will be
View solution
Q. Measurement of non-electrical quantity involves the following subsystems
1. Amplifier block
2. Display block
3. Instrumentation block
4. Transducer block
The correct sequence of these blocks is
View solution
Q. An oscilloscope has an input impedance consisting of 1 MΩ and 20 pF is parallel. A high impedance probe connected to input of this oscilloscope has a 10 MΩ series resistance. This 10 MΩ series resistance
View solution
Q. Which of the following is used as detector in audio frequency ac bridges?
View solution
Q. Assertion (A): The gall tinsley potentiometer is a coordinate potentiometer and has two exactly similar potentiometers.
Reason (R): An ac potentiometer may measure the unknown voltage in polar form or rectangular coordinate form.
View solution
Recommended Subjects
Are you eager to expand your knowledge beyond Electronics and Communication Engineering? We've handpicked a range of related categories that you might find intriguing.
Click on the categories below to discover a wealth of MCQs and enrich your understanding of various subjects. Happy exploring!
